Chapter 5 Obtain and Load EMM Data
Extract the EMM File
If you have properly followed the instructions in this section, the EMM TAR file has
been copied to the /dvs/dncs/emmcds directory on your DNCS. Extract the
individual components of your EMM TAR file to a directory on the DNCS. Record
the path and directory here:
___________________________________________________________
Extracting the EMM File
Follow these steps to extract the EMM file on your DNCS.
1 Open an xterm window on the DNCS.
2 Type cd /dvs/dncs/emmcds and press Enter. The /dvs/dncs/emmcds directory
becomes the working directory.
3 Type tar xvf [EMM file name] and press Enter.
Example: If your EMM file is named 0090387249drtvh.tar, as indicated in
previous examples, you would type the following:
tar xvf 0090387249drtvh.tar.
Results:
The system creates a subdirectory in the emmcds directory. The name of the
subdirectory is the name of the EMM file without the TAR extension and a
COMPLETE suffix.
Example: OL00272729-COMPLETE
Within this subdirectory is the following directory and file:
– A dncs subdirectory that contains the EMM data in directories and files
that the DNCS uses when you load the EMM data.
– The TOC file.
Important: If any of these are missing, contact Cisco Services.
4 Go to Copy the TOC File (on page 61).
To Next Page
Loading...
Need help?
General
