Cisco RV180W Administration Guide

Configuring VPN and Security
Configuring Advanced VPN Parameters
Cisco RV180/RV180W Administration Guide 112
5
confirmation message appears, click OK to continue with the deletion, or
otherwise click Cancel.
VPN Policies
In the VPN Policy Table, perform these tasks:
• To add a policy, click Add. Then enter the settings on the Add/Edit VPN
Policy Configuration page.
See Configuring VPN Policies, page 116.
Note: To create an Auto VPN Policy, you need to first create an IKE policy
and then add the corresponding Auto Policy for that IKE Policy.
• To edit a policy, check the box and then click Edit. Then enter the settings
on the Add/Edit VPN Policy Configuration page.
See Configuring VPN Policies, page 116.
• To delete a policy, check the box and then click Delete. To select all policies,
check the box in the heading row, and then click Delete. When the
confirmation message appears, click OK to continue with the deletion, or
otherwise click Cancel.
• To enable a policy, check the box and then click Enable. To select all
policies, check the box in the heading row, and then click Enable.
• To enable a policy, check the box and then click Disable. To select all
policies, check the box in the heading row, and then click Disable.
Configuring IKE Policies
Use the Add / Edit IKE Policy Configuration page to configure an IKE (Internet Key
Exchange) Policy. You can create IKE policies to define the security parameters
such as authentication of the peer, encryption algorithms, etc. to be used in this
process. Be sure to use compatible encryption, authentication, and key-group
parameters for the VPN policy.
To open this page: From the VPN > IPsec > Advanced VPN Setup page, in the
IKE Policy table, click Add or select an existing policy and click Edit.

Cisco RV180W Specifications

General

Brand	Cisco
Model	RV180W
Category	Network Router
Language	English