Cisco RV180W Administration Guide

2
Cisco RV180/RV180W Administration Guide 24
Configuring Networking
The networking page allows you to configure networking settings. This chapter
contains the following sections:
• Configuring the WAN (Internet) Settings, page 24
• Configuring the LAN (Local Network) Settings, page 31
• Configuring Routing, page 41
• Configuring Port Management, page 46
• Configuring Dynamic DNS (DDNS), page 47
• Configuring IPv6, page 49
NOTE Cisco recommends you use the Setup Wizard to configure basic networking on the
Cisco RV180/RV180W. You can then make changes and provision advanced
features using the Device Manager.
Configuring the WAN (Internet) Settings
If you have an IPv4 network, use these sections to configure your network. If you
have an IPv6 network, see Configuring IPv6, page 49.
Configuring the IPv4 WAN (Internet)
STEP 1 Choose Networking > WAN (Internet) > IPV4 WAN (Internet).
STEP 2 Choose the type of Internet connection you have.

Cisco RV180W Specifications

General

Brand	Cisco
Model	RV180W
Category	Network Router
Language	English