Managing MAC Address Tables
Dynamic MAC Addresses
Cisco Small Business 300 Series Managed Switch Administration Guide 143
13
Configuring Dynamic MAC Address Parameters
The
Dynamic Addresses Setting Page
enables entering the aging interval for the
MAC address table.
To enter the aging interval for dynamic addresses:
STEP 1 Click MAC Address Tables > Dynamic Address Settings. The
Dynamic Addresses
Setting Page
opens.
STEP 2 Enter Aging Time. The aging time is a value between the user-configured value and
twice that value minus 1. For example, if you entered 300 seconds, the aging time
is between 300 and 599 seconds.
STEP 3 Click Apply. The Dynamic MAC Address Table is updated.
Querying Dynamic Addresses
The
Dynamic Addresses Page
enables querying the Dynamic MAC Address table
according to the following criteria:
• Interface type
• MAC addresses
• VLAN
This page displays the dynamically-learned MAC addresses. You can clear the
dynamic addresses from the MAC address table and specify a query criteria to
display a subset of the table, such as the MAC addresses learned on a specific
interface. You can also specify how the query results are sorted. If no filter criteria
are entered, the entire table is displayed.
To perform query dynamic addresses:
STEP 1 Click MAC Address Tables > Dynamic Addresses. The
Dynamic Addresses Page
opens.
STEP 2 In the Filter block, enter the following query criteria:
• VLAN ID—Enter the VLAN ID for which the table is queried.
• MAC Address—Enter the MAC address for which the table is queried.
To Next Page
Loading...
Need help?
General
