Configuring SNMP
Notification Recipients
Cisco Small Business 300 Series Managed Switch Administration Guide 291
19
It is also possible to filter certain notifications. This can be done by creating a filter
in the Notification Filter Page and attaching it to an SNMP notification recipient.
The notification filter enables filtering the type of SNMP notifications that are sent
to the management station based on the OID of the notification that is about to be
sent.
Defining SNMPv1,2 Notification Recipients
To define a recipient in SNMPv1,2:
STEP 1 Click SNMP > Notification Recipient SNMPv1,2. The
SNMPv1,2 Notification
Recipient Page
opens.
This page displays recipients for SNMPv1,2.
STEP 2 Click Add. The
Add SNMP Notification Recipient Page
opens.
STEP 3 Enter the parameters.
• IP Version—Select either IPv4 or IPv6.
• IPv6 Address Type—Select either Link Local or Global.
- Link Local—The IPv6 address uniquely identifies hosts on a single
network link. A link local address has a prefix of FE80, is not routable, and
can be used for communication only on the local network. Only one link
local address is supported. If a link local address exists on the interface,
this entry replaces the address in the configuration.
- Global—The IPv6 address is a global Unicast IPV6 type that is visible and
reachable from other networks.
• Link Local Interface—If the IPv6 address type is Link Local, select whether
it is received through VLAN2 or ISATAP.
• Recipient IP Address—Enter the IP address of where the traps are sent.
• UDP Port—Enter the UDP port used for notifications on the recipient device.
• Community String—Enter the community string of the trap manager.
• Notification Type—Select whether to send traps or informs. If both are
required, two recipients must be created.
• Notification Version—Select the trap SNMP version.
Either SNMPv1 or SNMPv2 may be used as the version of traps, with only a
single version enabled at a single time.
To Next Page
Loading...
Need help?
General
