Status and Statistics
Managing RMON
Cisco 220 Series Smart Switches Administration Guide Release 1.1.0.x 31
2
• Interval—Enter the time in seconds that samples were collected from the
interface.
• Owner—Enter the RMON station or user that requested the RMON
information.
STEP 4 Click Apply. The RMON history control sample is added, and the Running
Configuration is updated.
STEP 5 Click History Table to view the actual statistics.
Viewing RMON History Statistics
The History Table page displays interface-specific statistical network samplings.
The samples are configured in the History Control Table described in the previous
section.
To view RMON history statistics:
STEP 1 Click Status and Statistics > RMON > History.
STEP 2 Click History Table.
STEP 3 Select the entry number to display the samples associated with that history entry,
and click Go.
The following fields are displayed for the selected history sample:
• History Entry No.—Number of the history entry.
• Owner—History entry owner.
• Sample No.—Statistics were taken from this sample.
• Drop Events—Number of dropped packets due to lack of network
resources during the sampling interval. This field may not represent the
exact number of dropped packets, but rather the number of times that
dropped packets were detected.
• Bytes Received—Number of octets received including bad packets and
FCS octets, but excluding framing bits.
• Packets Received—Number of packets received, including bad packets,
Multicast, and Broadcast packets.
• Broadcast Packets—Number of good Broadcast packets received. This
number does not include Multicast packets.
To Next Page
Loading...
Need help?
General
