EasyManuals Logo
Home>Cisco>Server>UCS C220 M5

Cisco UCS C220 M5 User Manual

Cisco UCS C220 M5
86 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #52 background imageLoading...
Page #52 background image
Replacing AC Power Supplies
If you have ordered a server with power supply redundancy (two power supplies), you do not have to power
off the server to replace a power supply because they are redundant as 1+1.
Note
Do not mix power supply types or wattages in the server. Both power supplies must be identical.
Note
Step 1 Remove the power supply that you are replacing or a blank panel from an empty bay:
a) Perform one of the following actions:
If your server has only one power supply, shut down and remove power from the server as described in Shutting
Down and Removing Power From the Server, on page 7.
If your server has two power supplies, you do not have to shut down the server.
b) Remove the power cord from the power supply that you are replacing.
c) Grasp the power supply handle while pinching the release lever toward the handle.
d) Pull the power supply out of the bay.
Step 2 Install a new power supply:
a) Grasp the power supply handle and insert the new power supply into the empty bay.
b) Push the power supply into the bay until the release lever locks.
c) Connect the power cord to the new power supply.
d) Only if you shut down the server, press the Power button to boot the server to main power mode.
Figure 28: Replacing AC Power Supplies
Power supply handle2Power supply release lever1
Replacing DC Power Supplies
This procedure is for replacing DC power supplies in a server that already has DC power supplies installed.
If you are installing DC power supplies to the server for the first time, see Installing DC Power Supplies (First
Time Installation), on page 54.
Note
Maintaining the Server
52
Maintaining the Server
Replacing AC Power Supplies

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco UCS C220 M5 and is the answer not in the manual?

Cisco UCS C220 M5 Specifications

General IconGeneral
Processor cache22 MB
Processor model6130
Execute Disable BitYes
Processor frequency2.1 GHz
Processor manufacturerIntel
Processor boost frequency3.7 GHz
Number of processors installed2
On-board graphics card-
Memory slots24
Internal memory64 GB
Internal memory typeDDR4-SDRAM
Maximum internal memory128 GB
SSD interfaceSerial Attached SCSI (SAS)
Optical drive typeNo
Supported HDD sizes2.5, 3.5 \
Supported SSD sizes2.5\
Total storage capacity32 GB
Maximum storage capacity- TB
Chassis typeRack (1U)
Power supply700 W
Intel TSX-NI version1.00

Related product manuals