Cisco UCS C220 M5 User Manual

Figure 29: Replacing DC Power Supplies
PSU status LED3Keyed cable connector
(CAB-48DC-40A-8AWG)
1
-Keyed DC input socket2
Installing DC Power Supplies (First Time Installation)
This procedure is for installing DC power supplies to the server for the first time. If you are replacing DC
power supplies in a server that already has DC power supplies installed, see Replacing DC Power Supplies,
on page 52.
Note
A readily accessible two-poled disconnect device must be incorporated in the fixed wiring.
Statement 1022
Warning
This product requires short-circuit (overcurrent) protection, to be provided as part of the building
installation. Install only in accordance with national and local wiring regulations.
Statement 1045
Warning
Installation of the equipment must comply with local and national electrical codes.
Statement 1074
Warning
Do not mix power supply types or wattages in the server. Both power supplies must be identical.
Note
Maintaining the Server
54
Maintaining the Server
Installing DC Power Supplies (First Time Installation)

Cisco UCS C220 M5 Specifications

General

Processor cache	22 MB
Processor model	6130
Execute Disable Bit	Yes
Processor frequency	2.1 GHz
Processor manufacturer	Intel
Processor boost frequency	3.7 GHz
Number of processors installed	2
On-board graphics card	-
Memory slots	24
Internal memory	64 GB
Internal memory type	DDR4-SDRAM
Maximum internal memory	128 GB
SSD interface	Serial Attached SCSI (SAS)
Optical drive type	No
Supported HDD sizes	2.5, 3.5 \
Supported SSD sizes	2.5\
Total storage capacity	32 GB
Maximum storage capacity	- TB
Chassis type	Rack (1U)
Power supply	700 W
Intel TSX-NI version	1.00