Cisco UCS C220 M5 User Manual

Step 5 Replace the server in the rack, replace cables, and then fully power on the server by pressing the Power button.
Figure 42: Location of the TPM Socket
-TPM socket location on motherboard below
any card in PCIe riser 2
1
Step 6 Continue with Enabling the TPM in the BIOS, on page 75.
Enabling the TPM in the BIOS
After hardware installation, you must enable TPM support in the BIOS.
You must set a BIOS Administrator password before performing this procedure. To set this password, press
the F2 key when prompted during system boot to enter the BIOS Setup utility. Then navigate to Security >
Set Administrator Password and enter the new password twice as prompted.
Note
Step 1 Enable TPM Support:
a) Watch during bootup for the F2 prompt, and then press F2 to enter BIOS setup.
b) Log in to the BIOS Setup Utility with your BIOS Administrator password.
c) On the BIOS Setup Utility window, choose the Advanced tab.
d) Choose Trusted Computing to open the TPM Security Device Configuration window.
e) Change TPM SUPPORT to Enabled.
f) Press F10 to save your settings and reboot the server.
Step 2 Verify that TPM support is now enabled:
a) Watch during bootup for the F2 prompt, and then press F2 to enter BIOS setup.
Maintaining the Server
75
Maintaining the Server
Enabling the TPM in the BIOS

Cisco UCS C220 M5 Specifications

General

Processor cache	22 MB
Processor model	6130
Execute Disable Bit	Yes
Processor frequency	2.1 GHz
Processor manufacturer	Intel
Processor boost frequency	3.7 GHz
Number of processors installed	2
On-board graphics card	-
Memory slots	24
Internal memory	64 GB
Internal memory type	DDR4-SDRAM
Maximum internal memory	128 GB
SSD interface	Serial Attached SCSI (SAS)
Optical drive type	No
Supported HDD sizes	2.5, 3.5 \
Supported SSD sizes	2.5\
Total storage capacity	32 GB
Maximum storage capacity	- TB
Chassis type	Rack (1U)
Power supply	700 W
Intel TSX-NI version	1.00