CITROEN 2002 BERLINGO User Manual

312
AIR
CONDITIONING
AIR
CONDITIONING
CHECKING THE EFFICIENCY OF THE AIR CONDITIONING SYSTEMALL TYPES
TOOLS
Two thermometers
Preliminary conditions.
Position of the air conditioning controls :
- Maximum cold air.
- Air blower in maximum position.
- Air distributor in "ventilation" position, with the dashboard vents open.
- Air intake flap in "exterior air" position.
Conditions and vehicle equipment.
- Boot closed.
- Doors and windows shut.
- Ensure the vehicle is in a sheltered area (away from wind, sun, etc..).
Checks
If all these conditions are met, take the following action :
- Start the engine, with the air conditioning off, and wait for the cooling fan
first speed to cut in.
- Operate the air conditioning and set the engine speed to 2500 rpm.
NOTE : If the ambient temperature reaches 40 °C, the engine speed will
return to 2000 rpm in order to prevent the compressor from being cut off
by the High Pressure safety device (Pressostat).
After the air conditioning has been on for three minutes, measure :
- the ambient temperature in the workshop,
- the temperature of the air coming from the central vents.
Compare the two values using the table overleaf.
CHECKING TEMPERATURES

CITROEN 2002 BERLINGO Specifications

General

Brand	CITROEN
Model	2002 BERLINGO
Category	Automobile
Language	English

Summary

GENERAL

IDENTIFICATION OF VEHICLES

Details on identifying vehicle specifics like engine type, chassis stamp, and plates.

ENGINE

ENGINE SPECIFICATIONS

Technical specifications for various engine types, including capacity, power, and torque.

TIGHTENING TORQUES

Specifies tightening torques for critical engine components like cylinder head and connecting rods.

VALVE TIMING CHECK AND SETTING

Step-by-step guide for checking and setting engine valve timing procedures.

AUXILIARY EQUIPMENT DRIVE BELT REPLACEMENT

INJECTION

PETROL INJECTION SPECIFICATIONS

Technical data for petrol injection systems, including fuel pressure and sensors.

PROHIBITED OPERATIONS AND SAFETY (HDI)

Lists prohibited operations and safety requirements for HDI injection systems.

CLUTCH, GEARBOX, DRIVESHAFTS

CLUTCH SPECIFICATIONS

Details clutch types, makes, and specifications for various models.

CLUTCH CHECKS AND ADJUSTMENTS

AXLES, SUSPENSION, STEERING

AXLE GEOMETRY (SAXO)

Measurements of front and rear axles at reference height for SAXO models.

FRONT AXLE SPECIFICATIONS

REAR AXLE SPECIFICATIONS

STEERING SPECIFICATIONS (XSARA PICASSO)

BRAKES

BRAKE SPECIFICATIONS (SAXO)

HANDBRAKE CHECKING AND ADJUSTMENT

BLEEDING THE BRAKES

BRAKE COMPENSATOR CHECKS AND ADJUSTMENTS

Procedures for checking and adjusting the load-sensitive brake compensator.