D R I V I N G
Never select positions P or
R if the vehicle is not sta-
tionary.
If, while the vehicle is mov-
ing, position N is engaged inad-
vertently, allow the engine to idle
before engaging position D or M .
Moving off
To start the engine, the selector
has to be in position P or N .
Action the starter.
When the engine is running,
place the selector on R , D or M
as required.
Check, in the instrument panel,
the position engaged.
Release the brake pedal and ac-
celerate.
To avoid incoherence between
the position of the selector and
the actual position of the gear-
box, always exit from position P
when you switch on the ignition
and press the brake pedal.
Otherwise, when the ignition is on or
the engine is running:
reposition the selector in position P ,
put your foot on the brake ped-
al and then select the gear you
want.
Park
This position of the selector
is used to prevent the vehi-
cle from moving when you
are stationary.
To select position P, move the
selector back to the highest po-
sition (towards R ), then push it
forwards and then to the left.
To exit position P , move the se-
lector to the right and then to the
position you want.
Only engage this position when
the vehicle is completely sta-
tionary. In this position, the front
wheels are locked. Make sure
that the selector is correctly po-
sitioned.
Reverse gear
Only engage this position
when the vehicle is station-
ary. To prevent snatching,
do not accelerate too soon
after selection.
Neutral
Never select position N if
the vehicle is moving.
To Next Page
Loading...
Need help?
General
