8
®
INSPECTION UPON RECEPTION
The units are shipped in special protective packaging. Check upon receipt that the unit has not been damaged during transport, and
that all the parts ordered are present. In the event of visible damage, immediately note the damage found on the shipping document,
writing: "ACCEPTED WITH RESERVATION DUE TO EVIDENT DAMAGE TO THE PACKAGING", as both freight-paid and freight-
charged deliveries are covered by insurance in accordance with Italian law no. 450, 22/08/85, "limits of compensation".
IMPORTANT
ALL THE FOLLOWING OPERATIONS MUST BE CARRIED OUT IN COMPLIANCE WITH THE SAFETY STANDARDS IN FORCE,
RELATING TO BOTH THE EQUIPMENT AND THE METHODS USED.
CAUTION
BEFORE PERFORMING THE HANDLING OPERATIONS, CHECK THAT:
- THE HOISTING CAPACITY IS SUITABLY-RATED FOR THE WEIGHT OF THE UNIT IN QUESTION
- THE DISTRIBUTION OF THE WEIGHTS AND THE POSITION OF THE CENTRE OF GRAVITY MUST BE CAREFULLY
CONSIDERED
WARNINGS
FOLLOWING THE SUGGESTIONS INDICATED ON THE OUTSIDE OF THE PACKAGING WILL ENSURE THAT THE UNIT IS
PHYSICALLY INTACT AND FUNCTIONAL, TO THE BENEFIT OF THE END USER. THEREFORE, PLEASE HEED THE
FOLLOWING WARNINGS:
- HANDLE WITH CARE
- KEEP DRY
- AVOID STACKING OTHER OBJECTS ON THE UNIT AT ALL COSTS (UNLESS THIS FALLS WITHIN THE LIMITS OF STACKED
LEVELS SHOWN ON THE PACKAGING).
- AVOID POSITIONING THE UNITS WITH PROTECTIVE HEAT-SHRINK PACKAGING IN DIRECT SUNLIGHT, AS THE
PRESSURE IN THE CIRCUITS MAY REACH VALUES AT WHICH THE SAFETY VALVES ARE ACTIVATED.
STORAGE
- Shelter from: direct sunlight, rain, sand and wind
- Temperature: maximum 60°C minimum -10°C
- Maximum humidity: 90%
- RECEPTION/POSITIONING -
HOISTING USING A CRANE OR SIMILAR
Position the lifting pipes, supplied, in the holes on the base of the unit.
Position the ends of the pipes that protrude from the unit so that the safety pins (supplied) can be placed in the corresponding holes.
Fit the lifting belts over the pipes between the safety devices and the base of the unit (see drawing).
Gradually bring the lifting belts under tension, making sure they are positioned correctly. Make sure the unit is always in steady
equilibrium.
Start hoisting the unit.
Once the unit has been positioned, remove the lifting pipes. These must be kept in a safe place, where they cannot damage people or
property, for any future positioning of the unit.
HANDLING USING A FORK LIFT OR SIMILAR
Insert the forks in the long side of the base, in the corresponding slots.
Start hoisting the unit, making sure the load is in steady equilibrium.
Reception/Positioning
To Next Page
Loading...
Need help?
General
