18
®
DISCONNECTING THE UNIT
- DECOMMISSIONING OF THE UNIT -
- The units must be disconnected by authorised personnel, who before proceeding must first read the Residual Risks section in this
manual.
- Before disconnecting the unit, the following must be recovered, if present:
1. the refrigerant (if the circuits cannot be isolated): the refrigerant must be removed using suction devices operating in a closed
circuit, so as to ensure that none of the compound is released into the atmosphere.
2. the antifreeze in the circuits: when removing this fluid, make sure than none leaks or is released into the environment. The
antifreeze fluid must be stored in special containers.
IMPORTANT:
When recovering the substances present in the unit, all measures must be taken to avoid damaging persons and things and polluting
the surrounding area.
- Awaiting dismantling and disposal, the unit can also be stored outdoors, as bad weather and rapid changes in temperature will not
cause damage to the environment.
DISMANTLING AND DISPOSAL
- THE UNIT MUST ALWAYS BE SENT TO AUTHORISED CENTRES FOR DISMANTLING AND DISPOSAL.
- When dismantling the unit, the fan, the motor and the coil, if operating, may be recovered by the specialist centres for
reuse.
NOTE:
For further information on the decommissioning of the unit, contact the manufacturer.
Decommissioning of the unit
- All the materials must be recovered or disposed of in compliance with the corresponding national standards in force.
To Next Page
Loading...
Need help?
General
