10
®
PLAN OF SPRING ANTIVIBRATION MOUNTS
1. n°4 holes Ø12
FUNCTIONAL CLEARANCES
IMPORTANT
WHEN PLACING THE UNIT, PLEASE MAKE SURE THAT THE FUNCTIONAL CLEARANCES ALLOW ALL MAINTENANCE
OPERATIONS TO BE PERFORMED. THIS IS REQUIRED FOR OPTIMUM UNIT OPERATION AND PARTICULARLY FOR THE
SAFETY OF AUTHORISED PERSONNEL AND EXPOSED PERSONS
The units require minimum clearances for operation and maintenance. In the event of multiple units, the functional clearances must be
doubled. The following sketches regard some types of installation; check on a case-by-case basis, considering the information
provided in this manual.
INSTALLATION OF ANTIVIBRATION MOUNTS
Spring or rubber (depending on the type of unit) antivibration mounts can be supplied upon request; in this case flexible joints (not
supplied by Clivet) are required for the hydraulic / aeraulic / refrigerant connections.
The tables and the drawings show the instructions for the installation of the antivibration mounts, with the part numbers of the
antivibration kits and their composition for correct installation.
The kits also include the assembly instructions.
INSTALLATION WITH JACK FOR UNIT LEVELLING
1. Minimum dimensions suggested
2. Jack
3. Plate
4. Clamps drowned in the concrete (not supplied)
5. Concrete foundation
* Unloaded height
INSTALLATION DIRECT-TO-FRAME
1. Minimum dimensions suggested
2. Clamps drowned in the concrete (not supplied)
3. Concrete foundation
* Unloaded height
Reception/Positioning
REMOVING THE PACKING
When removing the packaging the operator should, for personal safety, use suitable protective materials (gloves, glasses etc.)
Check for any visible damage.
Dispose of the packaging by taking it to specialist collection or recycling centres (in accordance with local regulations).
Remove the polystyrene packaging and the corresponding fasteners, making sure not to damage the unit.
1
5
0
0
1
5
0
0
1500
900
1
2
3
4
5
2
3
1
1
To Next Page
Loading...
Need help?
General
