Compac C4000 User Manual

Fault Finding
Error Messages
Compac Industries Ltd.
Page 71
www.compac.co.nz
Error Messages
On Pump
LCD
Display
On PIN Pad Dot
Matrix Display (if
Connected)
Explanation
REPAS
Pass Again
Card not read properly, try re-swiping. In addition, C4000 may be configured for
the wrong card reader track, or the card or card reader could be faulty.
HOLD
System not ready
Pump no longer communicating with Central Controller.
:0.0
The full-colon on the display indicates that the processor supply has been OFF
and back ON since the last transaction.
_ _ _ _ _
Restricted Fuel
Card not validated for the pump/dispenser fuel grade set.
_ _ _ _ _
Wrong System
Incorrect card used or the controller has the incorrect access code or ISO number
set. Or requires setting for a particular Card Type.
_ _ _ _ _
Expired Card
Card expiry date is earlier than controller date
_ _ _ _ _
Bad Card
Algorithm check sum on cards is invalid
_ _ _ _ _
Wrong Pin
An incorrect or invalid pin has been entered.
_ _ _ _ _
Wrong Network
The network encoded on the card is invalidated in the controller.
RAnGE
Temperature probe out of range. (Only displayed when temperature setting
selected on K Factor Switch). Probe either faulty or not connected.
Low Battery
Fault on Secure PIN pad Processor PCB- replace complete PIN pad.
Memory Error
Fault on Secure PIN pad processor PCB replace complete PIN pad.
AIr
(Flashing)
The air cut-out switch has operated.
GAS
(flashing)
LPG ONLY. Flow rate fell to between 0 and 6 litres/min for more than 6 seconds.
Indicates creepage due to presence of vapour.

Compac C4000 Specifications

General

Brand	Compac
Model	C4000
Category	Control Unit
Language	English