adjustments to compensate for wear
ADJUSTING BEVEL LOCK LEVER
The purpose of this lever is to lock the motor at any
angle. To adjust, remove the set screw with wrench as
shown. Use the bevel lock lever as a wrench to tighten
the clamp bolt. Do Not Over Tighten. Replace bevel
lock lever in locked position and tighten the set screw.
J
_'_%" BEVEL LOCK LEVER
IN LOCKED POSITION
BEVEL LOCK
LEVER
t
1/8 HE× "k" WRENCH
YOKE LOCK HANDLE ADJUSTMENT.
1. This handle provides a friction lock between the upper
face of the yoke and the bottom face of the carriage.
It should eliminate any play or rotation between these
two parts when locked. Its proper position for saw
operation is _pproximately midway between the two
sides of the yoke.
When sufficient wear has occured to permit the handle
to move considerably to the rear, or strike the yoke
before locking, the handle must be adjusted as follows:
2. Remove carriage stop screw and Iockwasher with a 1/4
inch hex-L wrench.
3. Grasp the carriage assembly, move it carefully off the
end of radial arm, holding it parallel to the radial arm
until all carriage bearings are free of their tracks.
4. Rest the mo[or and carriage assembly on saw work
table and re-install carriage stop screw and tockwasher.
LC
CARRIAGE STOP
SCREW
HEX '1_" WRENCH
(1/4 INCH)
To Readjust
5.
Set yoke lock handle at unlocked position. Tighten nut
with 15/16 wrench, until lock handle locks mid-way
between the two sides of the yoke. Remove carriage
stop screw and Iockwasher.
6. Hold the motor and carriage assembly parallel to radial
arm and start the rear bearings onto the tracks.
Continue to hold the assembly parallel to the tracks
until the forward bearings are on the tracks.
7. Slide the carriage rearward on the radial arm and
INSTALL THE CARRIAGE STOP SCREW AND
LOCKWASHE R.
15/16 WR ENCH
/
28
To Next Page
Loading...
Need help?
General