4 Web-based Switch Configuration D-Link Smart Managed Switch User Manual
1
1
1
1
5
5
Figure 4.144 –SNMP > SNMP > SNMP Community
Click Add to create a new SNMP community, Delete to remove an existing community.
SNMP > SNMP > SNMP Host
This SNMP Host page is to configure the SNMP trap recipients.
Figure 4.145 – SNMP > SNMP > SNMP Host
Host IP Address: Select IPv4 or IPv6 and specify the IP address of SNMP management host.
SNMP Version: Specifies the SNMP version to be used to the management host.
Community String/SNMPv3 User Name: Specifies the community string or SNMPv3 user name for the
management host.
Click Apply to create a new SNMP host, Delete to remove an existing host.
SNMP > SNMP > SNMP Engine ID
The Engine ID is a unique identifier used to identify the SNMPv3 engine on the Switch.
Input the Engine ID then click Apply to apply the changes and click Default resets to default value.
Figure 4.146 – SNMP > SNMP > SNMP Engine ID
SNMP > RMON > RMON Global Settings
Users can enable and disable remote monitoring (RMON) status for the SNMP function on the Switch. In
addition, RMON Rising and Falling Alarm Traps can be enabled and disabled. Click Apply to make effects.
Figure 4.147 - SNMP > RMON > RMON Global Settings
To Next Page
Loading...
Need help?
General
