5 Surveillance Mode Configuration D-Link Smart Managed Switch User Manual
1
1
3
3
1
1
Figure 5.17 – Surveillance Mode > Health Diagnostic – Port Information / Group Details
Click Back to go to the previous page.
Tool Bar > Wizard
By clicking the Wizard button, you can return to the Smart Wizard if you wish to make any changes there.
For the Smart Wizard configuration, you can refer to the Chapter 4 Smart Wizard Configuration
.
Tool Bar > Tools Menu
The Tools Menu offers global function controls such as Reset System, Reboot Device, Configuration Backup
& Restore, Firmware Backup & Upgrade, Firmware Information and Flash Information.
Figure 5.18 – Surveillance Mode > Tools Menu
Reset System
Provide a safe reset option of Surveillance VLAN for the Switch. All configuration settings in non-volatile
RAM will be reset to factory default except for the IP address.
Figure 5.19 – Surveillance Mode > Tools Menu > Reset
Select one of the following options:
• Warning!! The Switch will be reset to its factory defaults, and then will reboot. – To reset the
Switch’s configuration to its factory default settings.
• Warning!! The Switch will be reset to its factory defaults except IP address, and then will
reboot. – To reset the Switch’s configuration to its factory default settings. This option will exclude the
IP address from being changed.
Click the Apply button to initiate the factory default reset and reboot the Switch.
To Next Page
Loading...
Need help?
General