D-Link DGS-1210-52MP User Manual

6 Command Line Interface D-Link Smart Managed Switch User Manual
1
1
3
3
7
7
Command Parameter
reset config
show boot_file
show firmware
information
show flash
information
show ipif [<ipif_name>]
show switch
show route {ipv4 | ipv6}
config account admin password <passwd>
save
debug info
Each command is listed in detail, as follows:
?
Purpose To display a list of commands.
Syntax
?
Description
The ? command displays a list of commands of the switch.
Parameters None.
Restrictions None.
Example usage:
To display a list of commands of the switch:
DGS-1210-52MP> ?
USEREXEC commands :
config account admin password <passwd>
config firmware image_id <integer (1-2)> {delete | boot_up }
config ipif <ipif_name> { ipaddress <ip-address> <subnet-mask> gateway <gw-add
ress> | dhcp | bootp }
config ipif <ipif_name> { ipv6 ipv6address <ipv6networkaddr> | dhcpv6_client {
enable | disable}}
debug info
download {firmware_fromTFTP {<ipaddr>| <ipv6addr>} <path_filename (64)> image_
id <integer 1-2> | cfg_fromTFTP {<ipaddr>| <ipv6addr>} <path_filename (64)>}
logout
ping <ip_addr>
ping6 <ipv6addr>
reboot
reset config
save

D-Link DGS-1210-52MP Specifications

General

PoE Standard	IEEE 802.3af/at
PoE Budget	370W
Switching Capacity	104 Gbps
Forwarding Rate	77.4 Mpps
MAC Address Table Size	16K
Power Input	100-240 VAC, 50/60 Hz
Ports	48 x 10/100/1000BASE-T PoE+, 4 x Gigabit SFP
Jumbo Frame Support	9216 Bytes
Dimensions	440 x 250 x 44 mm
Operating Temperature	0 to 50 °C
Storage Temperature	-40 to 70 °C (-40 to 158°F)
Humidity	5% to 95% non-condensing