Daikin BRC1E63 - Setting the Cool;Heat Selection Eligibility; Setting Changes; Selection Settings

18
Setting the Cool/Heat Selection Eligibility
(VRV only)
Setting Changes
Refer to “Cool/Heat Selection Eligibility” on page19 for an explanation of the
cool/heat selection eligibility.
1
Cool
Cool
• Press Mode Selector button on the remote controller
that has cool/heat selection eligibility for at least
4seconds. (During backlight lit)
A remote controller will not display
“
” (Changeover Under Control) if a cool/heat
selection eligibility is granted to the remote
controller.
• The icon “ ” on each remote controller of indoor units
connected to the same outdoor unit or BS unit will start blinking.
* Vent mode setting changes are possible regardless of the cool/
heat selection eligibility.
* If a cool/heat selection eligibility is set in the “Cool/Heat selector”
(
), all the remote controllers will display the icon “ ” . In this
case, no cool/heat selection eligibility can be set in the remote
controllers.
Refer to the Operation Manual attached to the outdoor unit for
the details of the “Cool/Heat selector”.
• Set a cool/heat selection elig bility as follows.
Selection Settings
The icon “ ” (Changeover Under Control) will blink on all remote
2
Cool
Cool
• Press Mode Selector button on the remote
controller for which the selection eligibility to be
set.
Then the cool/heat selection eligibility will be set
and the icon “
” will disappear.
The icon “
” will appear on the other remote
controllers.
Set to
28°C
Set to
28°C
Set to
28°C
Set to
28°C