Danfoss H1B 060 User Manual

Formulas to calculate start and end input command
Control type Input command (mA) % displacement All sizes (mA)
K1
Start input command from 0% 480 ± 10
from x % max. (V
gx
/V
gmax
) x 1110 + 480
End input command at 100 % 1590 ± 130
at y % max. (V
gy
/V
gmax
) x 1110 + 480
Maximum allowed current 1800
K2
Start input command from 0% 240 ± 5
from x % min. (V
gx
/V
gmax
) x 570 + 240
End input command at 100 % 810 ± 67
at y % max. (V
gy
/V
gmax
) x 570 + 240
Maximum allowed current 920
Where:
V
gmax
Maximum, theoretic possible motor displacement per revision (cm
3
/rev)
V
gx
Minimum displacement setting of desired unit (cm
3
/rev)
V
gy
Maximum displacement setting of desired unit (cm
3
/rev)
x Minimum displacement (%)
y Maximum displacement (%)
Proportional solenoid data C1
Description 12 V 24 V
Maximum current
1800 mA 920 mA
Nominal coil resistance @ 20 °C [68 °F]
3.66 Ω 14.20 Ω
@ 80 °C [176 °F]
4.52 Ω 17.52 Ω
Inductance
33 mH 140 mH
PWM Range
70-200 Hz
Frequency (preferred)
*
100 Hz
IP Rating IEC 60 529
IP 67
DIN 40 050, part 9
IP 69K with mating connector
Connector color
Black
*
PWM signal required for optimum control performance.
W
Warning
Zero degree capability results in a high risk of overspeed and drops in efficiency if the motor operates
between 0–20% displacement.
Technical Information
H1 Bent Axis Variable Displacement Motors, Size 060/080/110/160/210/250
Controls – nomenclature, description
©
Danfoss | December 2016 11037153 | BC00000043en-US1103 | 51

Danfoss H1B 060 Specifications

General

Brand	Danfoss
Model	H1B 060
Category	Engine
Language	English