CONNECTING THE HOST INTERFACE
PRODUCT REFERENCE GUIDE
9
USB Connection
Connect the reader to a USB port on the terminal/PC using the correct USB cable for the
interface type you ordered.
USB:
Select to communicate either by USB OEM, USB COM STD or USB Keyboard inter-
face types by scanning the appropriate interface type bar codes available in this manual.
The default interface is USB-KBD, or RS-232-STD.
Figure 1 - Connection to the Host
NOTE: Specific cables are required for connection to different hosts. The
connections illustrated in the following page are examples only. Actual
connectors may vary from those illustrated, but the steps to connect the
reader remain the same.
RS-232
USB
CM9680 ETHERNET
1
3
2
4
1
2
3
2
1
To Next Page
Loading...
Need help?
General
