ENTER/EXIT PROGRAMMING MODE WIRELESS FEATURES
312
POWERSCAN™ PD/PM/PBT9600
STAR Frequency Agility
In exceptionally noisy environments or in case of a high concentration of radio devices,
the STAR system performance may be improved by enabling the STAR Frequency Agility
feature. This feature changes the way the radio frequencies are used in a STAR commu-
nication system.
As in the case of the STAR System Speed, use the following procedure:
1. link the Reader to the Base;
2. scan the ENTER/EXIT PROGRAMMING MODE bar code above; read either the
“Enable” or “Disable” programming label below to Enable or Disable the feature;
end by scanning the ENTER/EXIT bar code again.
3. place the Reader into the Base.
The Reader and the Base will be linked and the new frequency handling strategy will be
operational.
NOTE: PowerScan 433 MHz Star models do not support all combinations of
STAR System Speed and STAR Frequency Agility (see "
STAR Frequency
Agility" on page 312
) configuration parameters. Please refer to Table 9 on
page 313 for the allowed combinations.
$CSTCP03
STAR System Speed = High Speed
STAR System Speed = Low Speed
$CSTCP01
NOTE: It is possible to configure the STAR system to use a fixed channel
with different frequency from the default one. Please contact Datalogic
Technical Support for information about this feature. Please refer to
Table 9 on page 313 for valid combinations of this feature with the STAR
System Speed configuration parameter.
NOTE: PowerScan 433 MHz Star models do not support all combinations of
STAR Frequency Agility and STAR System Speed (see "
STAR System Speed"
on page 311
) configuration parameters. Please refer to Table 9 on page 313
for the allowed combinations.
To Next Page
Loading...
Need help?
General
