SET STRING TERMINATOR ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
275
Set String Terminator
Sets the terminator of the predefined strings.
Set String Terminator
$CPWEF
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left, and then read 32 digits representing 16 ASCII
characters in Appendix G, Keypad.
The digits must be the hexadecimal ASCII represen-
tation of the desired characters. If less than the
expected string of 16 characters are selected, scan
the ENTER/EXIT bar code to terminate the string.
If the first 2 digits are 0, the feature is disabled. End
by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
0x00000000000000000000000000000000
To Next Page
Loading...
Need help?
General
