360
POWERSCAN™ PD/PM/PBT9600
APPENDIX C
STANDARD DEFAULTS
The most common configuration settings are listed in the “Default” column of the table
below. Page references are also provided for feature descriptions and programming bar
codes for each parameter. A column has also been provided for recording of your pre-
ferred default settings for these same configurable features.
Table 38 Standard Defaults
PARAMETERS DEFAULT
YOUR SETTING PAGE NUMBER
GLOBAL INTERFACE FEATURES
Host Commands — Obey/Ignore Obey 43
USB Suspend Mode Enable 43
RS-232 ONLY
Baud Rate 115,200 45
Data Bits 8 Data Bits 46
Stop Bits 1 Stop Bit 46
Parity None 47
Handshaking Control RTS 48
RS-232/USB-COM
Intercharacter Delay No Delay 50
Beep On ASCII BEL Disable 51
Beep On Not on File Enable 51
ACK NAK Options Disable 52
ACK Character ‘ACK’ 53
NAK Character ‘NAK’ 53
ACK NAK Timeout Value 200 msec 54
ACK NAK Retry Count 3 Retries 53
ACK NAK Error Handling Ignore Errors Detected 55
To Next Page
Loading...
Need help?
General
