Product Reference Guide 277
Chapter 6
References
This section contains explanations and examples of selected bar code features.
See the programming sections for the actual bar code labels used to configure
the reader.
RS-232 PARAMETERS
on page 278
•
Intercharacter Delay on page 278
•
ACK Character on page 279
•
NAK Character on page 280
•
ACK NAK Timeout Value on page 281
•
ACK NAK Retry Count on page 282
•
Disable Character on page 283
•
Enable Character on page 284
KEYBOARD WEDGE
on page 285
•
Wedge Quiet Interval on page 285
•
Intercharacter Delay on page 286
•
Intercode Delay on page 287
DATA EDITING
on page 288
•
Data Editing Overview on page 288
•
Global Prefix/Suffix on page 289
•
Global AIM ID on page 290
•
Label ID: Pre-loaded Sets on page 291
•
Label ID: Set Individually Per Symbology on page 293
•
Set Global Mid Label ID Character(s) on page 295
•
Character Conversion on page 295
READING PARAMETERS
on page 297
•
Label Gone Timeout on page 297
•
Good Read LED Duration on page 298
•
Scan Mode on page 299
•
Scanning Active Time on page 300
•
Flash On Time on page 301
•
Flash Off Time on page 302
SYMBOLOGY SETTINGS
on page 303
•
Decoding Levels on page 303
•
Set Length on page 304
RF FEATURES
on page 306
•
Automatic Configuration Update on page 306
•
RF Address Stamping on page 306
•
BT Pin Code on page 308
To Next Page
Loading...
Need help?
General
