Enter/Exit Programming Mode Character Conversion
68 QuickScan™ I QM21X1 / QBT21X1
Character Conversion
Character conversion is an eight byte configuration item. The eight bytes are 4
character pairs represented in hexadecimal ASCII values. The first character in
the pair is the character that will be converted. The second character in the pair
is the character to convert to. If the character to convert in a pair is FF, then no
conversion is done. See "Character Conversion" on page 295 for more detailed
programming instructions.
$CLFCH
Configure Character Conversion
DEFAULT
0xFFFFFFFFFFFFFFFF
(No character conversion)
To Next Page
Loading...
Need help?
General
