Description Notes
CBE activated
The tie breaker is allowed to close before the genset is excited. This is typically used for
asynchronous gensets.
CBE deactivated The tie breaker is not allowed to close before the genset is excited.
CBE test relay(s) activated
4.5 Redundancy events
More information
See the document Description of options: Option T1 Critical power for information about Redundancy events.
4.6 Maintenance box
These events are for the remote maintenance box (RMB). They are only available for genset controllers.
More information
See Option T4 Remote maintenance box with multiple gensets for more information.
4.7 Command timers
Description Notes
Cmd timer [01-04] active
The command timers (1 to 4) will operate in pairs to activate and deactivate a flop flop
function.
Any Cmd timers active Any command timers will operate in pairs to activate and deactivate a flop flop function.
4.8 CAN inputs
More information
See Option G5 Power management for information about CAN Inputs.
4.9 Display
Description Notes
Display [1-3] primary When more displays are used, set the display [1-3] as the primary.
4.10 PM compatibility
More information
See Option G5 Power management for information.
4.11 Static synchronisation type
These events are only available in genset controllers.
Description
Notes
GB: Breaker Static sync. of the GB is set to Breaker Sync.
GB: Infinite Static sync. of the GB is set to Infinite Sync.
Application note 4189341276B EN Page 26 of 50
To Next Page
Loading...
Need help?
General
