Description Notes
Access lock Activates access lock.
Select L1L2L3 phase rotation Activates L1L2L3 as phase rotation direction.
Select L1L3L2 phase rotation Activates L1L3L2 as phase rotation direction.
TB configuration: Normal close Change the tie breaker in the application configuration to Normally closed.
TB configuration: Normal open Change the tie breaker in the application configuration to Normally open.
5.1.5 Plant controller commands
Commands for plant
Description
Notes
Island Island function mode.
AMF AMF (Automatic Mains Failure) function mode.
Peak shaving Peak shaving function mode.
Fixed power Fixed power function mode.
Mains power export Mains power export function mode.
Load take over Load take over function mode.
Semi-Auto mode Semi-auto running mode.
Test mode Test running mode.
Auto mode Auto running mode.
Block mode Block running mode.
Lamp test Activate lamp test (LEDs on display).
Ack. all alarms Acknowledge all alarms.
Set to local start Select local start in a power management application.
Set to remote start Select remote start in a power management application.
Set clock to 4 am Set the controller clock to 04h00.
Switch log to print Switch between event, alarm and battery log to print.
Print log Print output.
Print status Print output.
Set parameter [1-4] Choose the parameter set for nominal settings.
Select test type to simple Test sequence selection.
Select test type to load Test sequence selection.
Select test type to full Test sequence selection.
Activate capacity overrule Activates power capacity overrule.
Deactivate capacity overrule Deactivates power capacity overrule.
Select application [1-4] Power management: Select the application from the controller.
Run my ID constant Runs the connected mains (constant)
Run my ID activate Runs the connected mains (one shot)
Run one mains Only one mains breaker is closed at the time.
Run all mains All mains breakers are closed at the time.
Update mode local Running mode update for the local controller.
Application note 4189341276B EN Page 41 of 50
To Next Page
Loading...
Need help?
General
