Deif AGC-4 Mk II User Manual

5. List of outputs
5.1 Commands
5.1.1 Genset controller commands
Output, Command
Description Notes
Lamp test Activate lamp test (LEDs on display).
Ack. all alarms Acknowledge all alarms.
Set clock to 4 am Set the controller clock to 04h00.
Derate Pnom [1-3] Activate nominal power derate.
Select test type to simple Test sequence selection.
Select test type to load Test sequence selection.
Select test type to full Test sequence selection.
Freeze ramp Locks the power ramp up function until the command is disabled again.
Idle run low speed Idle speed constant low speed.
Idle run temp control Idle speed temperature-dependent.
Cool down threshold Interrupt cool down sequence.
Inductive reference Inductive cos phi reference.
Capacitive reference Capacitive cos phi reference.
Act. dynamic sync. Activate dynamic sync.
Act. static sync. Activate static sync.
Fan A running Running feedback for cooling fan A.
Fan B running Running feedback for cooling fan B.
Fan C running Running feedback for cooling fan C.
Fan D running Running feedback for cooling fan D.
Act. power offset [1-3] Activate the power reference offset.
Deact. power offset [1-3] Deactivate the power reference offset.
Act. cos phi offset [1-3] Activate cos phi reference offset.
Deact. cos phi offset [1-3] Deactivate cos phi reference offset.
Activate Fuel Pump Override fuel pump hysteresis to fill the tank to threshold level.
Reset horn Reset the horn relay.
Reset I max. demand Reset the peak current detected in the controller.
Reset I thermal demand Reset the thermal current detected in the controller.
Pulse counter [1-2] Increase the selected pulse counter.
Reset pulse counter [1-2] Reset the selected pulse counter.
Force use of analogue offset [1-4] This command forces the selected analogue offset to be active.
Mains sync. inhibit activate Activates the close inhibit functionality on the mains breaker.
Mains sync. inhibit deactivate Deactivates the close inhibit functionality on the mains breaker.
Ack. mains protection alarms
Acknowledges all mains alarms including: 1270-1430, 1660, 1700, 1960, 1970,
7480-7490.
Application note 4189341276B EN Page 33 of 50

Deif AGC-4 Mk II Specifications

General

Brand	Deif
Model	AGC-4 Mk II
Category	Controller
Language	English