74 Driver Installation
Installing Solaris Driver
Use the procedures in this section to install the driver for Solaris 10. To ensure
that you have the current version of the driver, download the updated Solaris
driver from the Dell Support website at support.dell.com.
The package is a gzipped .tar file. Download the package to a Solaris system,
and perform the following steps:
1
Extract the package contents:
gunzip -
c <driver_package.tgz> | tar xvf –
2
Use the
dd
command to create a driver update disk. Use the appropriate
image for the purpose. Type:
dd if=./mega_sas.img of=
/<diskette drive device node> bs=32k
NOTE: If you are uncertain which device node corresponds to your diskette
drive, execute the rmformat command and search for the correct Logical
Node.
NOTE: You can create a DUD on a system running the Windows operating
system using the program dcopynt.
3
If you prefer, you may use the cdrecord command to create a CDROM
instead of a floppy image. Type:
cdrecord dev=
<bus>,<target>,<lun> mega_sas_cd.iso
NOTE: To identify the correct location of the bus, target, and logical unit
number (LUN) combination, execute the following command:
cdrecord --scanbus
Installing Solaris 10 on a PowerEdge System Booting From a PERC 6
or CERC 6/i Controller
To install the driver during Solaris 10 operating system installation:
1
Boot the system from the Solaris installation media and select the
preferred console.
2
After Solaris finishes configuring devices, a menu displays.
Select
Apply Driver Updates
.
3
Select [
1
] if you created a CD from the
mega_sas_cd.iso
file.
4
Select [
2
] if you created a diskette from the
mega_sas.img
file and you are
using a traditional diskette drive.
Dell_PERC6.2_UG.book Page 74 Wednesday, June 24, 2009 6:08 PM
To Next Page
Loading...
Need help?
General
