Figure 89. Installing the expansion card in the Riser 1B
Next steps
1. Reconnect the expansion card cables to the system board.
2. Install the air shroud.
3. Follow the procedure listed in After working inside the system.
4. Install any device drivers required for the card as described in the documentation for the card.
NOTE:
While replacing faulty storage controller/FC/NIC card with the same type of card, after you power on the system;
the new card automatically updates to the same firmware and configuration of the faulty one. For more information about
the Part replacement configuration, see the Lifecycle Controller User's Guide at https://www.dell.com/idracmanuals
Optional IDSDM module
Removing the IDSDM module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the air shroud.
4. If you are replacing the IDSDM card, remove the MicroSD cards.
NOTE:
Temporarily label each SD card with its corresponding slot number before removal. Reinstall the SD cards into
the corresponding slots.
Steps
Holding the blue pull tab, lift the IDSDM card out of the system.
98
Installing and removing system components
To Next Page
Loading...
Need help?
General
