Option Description
Date/Time Allows you to change the date and time.
Video screen options
Option Description
LCD Brightness Allows you to set the display brightness depending up on the power source (On Battery and On AC).
NOTE: The video setting will be visible only when a video card is installed into the system.
Security screen options
Option
Description
Admin Password Allows you to set, change, or delete the administrator (admin) password.
NOTE: You must set the admin password before you set the system or hard drive password. Deleting
the admin password automatically deletes the system password.
NOTE: Password changes take effect immediately.
By default, the drive will not have a password set.
System
Password
Allows you to set, change or delete the system password.
NOTE: Password changes take effect immediately.
By default, the drive will not have a password set.
Password
Configuration
Allows you to determine the minimum and maximum length of Administrator and System passwords.
Password Bypass Allows you to disable or enable the permission to bypass the System and the Internal hard drive password,
when they are set. The options are:
● Disabled. This option is selected by default.
● Reboot bypass
Password
Change
Allows you to enable or disable permission to the System and Hard Drive passwords when the admin
password is set.
Allow Non-Admin Password Changes This option is selected by default.
UEFI Capsule
Firmware
Updates
This option controls whether the system allows BIOS updates via UEFI capsule update packages.
Enable UEFI Capsule Firmware Updates option is selected by default.
NOTE: Disabling this option will block BIOS updates from services such as Microsoft Windows
Update and Linux Vendor Firmware Service (LVFS).
TPM 2.0 Security Allows you to enable the Trusted Platform Module (TPM) during POST.
You can control whether the trusted platform module is visible to the operating system. The option is:
● TPM on This option is selected by default.
● Clear
● PPI Bypass for Disable Commands
● PPI Bypass for Clear Command" in TPM 2.0 Security.
● Attestation Enable. This option is selected by default.
● PPI Bypass for Disable Commands
● Key Storage Enable. This option is selected by default.
● SHA-256. This option is selected by default.
62 System setup
To Next Page
Loading...
Need help?
General
