162 Dell PowerConnect 28xx Systems User Guide
Command Mode
Privileged EXEC
Usage Guidelines
The location of a file system dictates the format of the source or destination URL.
The entire copying process may take several minutes and differs from protocol to protocol and from
network to network.
If the egress interface is not specified, the default interface will be selected. Specifying interface zone=0
is equal to not defining an egress interface.
Understanding Invalid Combinations of Source and Destination
Some invalid combinations of source and destination exist. Specifically, you cannot copy the following:
• If the source file and destination file are the same file.
•
xmodem:
can't be destination. Can be copied to
image
,
boot
and
null:
only.
•
tftp:
can't be source and destination on the same copy.
• *.prv files can't be copied.
• Copy to or from the slave units is for image and boot files only.
copy Character Descriptions
Command: debug-mode
To switch to debug mode, use the debug-mode command in Privileged EXEC mode.
debug-mode
Syntax Description
This command has no arguments or keywords.
Command Mode
Privileged EXEC
Table A-2. Source and Destination Keywords
Character Description
! For network transfers, an exclamation point indicates that the copy process is taking
place. Each exclamation point indicates the successful transfer of ten packets (512
bytes each).
. For network transfers, a period indicates that the copy process timed out. Many
periods in a row typically mean that the copy process may fail.
To Next Page
Loading...
Need help?
General