Dell PowerConnect 28xx Systems User Guide 17
2
Hardware Description
Switch Port Configurations
PowerConnect 28xx Front and Back Panel Port Description
The Dell™ PowerConnect™ 28xx switches use 10/100/1000BASE-T ports on the front panel for
connecting to a network.
The Gigabit Ethernet ports can operate at 10, 100 or 1000 Mbps. These ports support auto-
negotiation, duplex mode (Half or Full duplex), and flow control. The combo 1000 Mbps optical
ports can only operate at 1000 Mbps, full-duplex mode.
The following figures illustrate the front panels and back panels of the PowerConnect 28xx switches.
Figure 2-1. PowerConnect 2808 Front Panel
On the front panel there are eight ports which are numbered 1 to 8, top down and left to right. On
each port there are LEDs (Light Emitting Diode) to indicate the port status.
On the left side of the front panel is the Managed Mode LED which indicates the Ethernet switch
operational status and the management mode. The Power LED on the front panel indicates whether
the device is powered on or not. A Mode push-button, located on the right side on the front panel is
used to transition between management modes and to reset the device. For more information about
management modes and transitioning between them, see "Management Modes" on page 49.
To Next Page
Loading...
Need help?
General