Dell PowerConnect 2816 User Manual

Dell PowerConnect 28xx Systems User Guide 171
show interfaces counters
show users
show sessions
show logging file
show logging
If you specify the memory keyword, the show tech-support command displays the output:
flash info (dir if existed, or flash mapping)
buffers info (like print os buff)
memory info (like print os mem)
proc info (like print os tasks)
Command: snmp-server community
Use the snmp-server community command to set up the community access string to permit access to
the Simple Network Management Protocol command. Use the no form of this command removes the
specified community string.
snmp-server community
community [ro | rw | su] [ ipv4-address ]
no snmp-server community
community [ ipv4-address ]
Syntax Description
• community — Community string that acts like a password and permits access to the SNMP protocol.
•
ro — Specifies read-only access (Default)
•
rw — Specifies read-write access
•
su — Specifies SNMP administrator access
•
ipv4-address — Management station IPv4 address. Default is all IP addresses.
Parameters range
• community — 1 - 20 chars
•
ip-address — Valid IP address
Default
No community is defined
Command Mode
Global configuration

Dell PowerConnect 2816 Specifications

General

Ports	16 x 10/100/1000BASE-T
Switching Capacity	32 Gbps
Forwarding Rate	23.8 Mpps
VLAN Support	Yes, up to 256 VLANs
Rack Mountable	Yes, 1U
Relative Humidity	10% to 90% non-condensing
Management	Web-based, CLI
MAC Address Table Size	8K MAC addresses
Operating Temperature	0°C to 45°C (32°F to 113°F)
Storage Temperature	-20°C to 70°C
Jumbo Frame Support	Yes
Dimensions	440 x 257 x 44 mm (17.3 x 10.1 x 1.7 in)