50 Drives
Installing a Hard Drive
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
1
Follow the procedures in "Before You Begin" on page 9.
2
Remove the computer cover (see "Removing the Computer Cover" on
page 13).
3
Remove the existing hard drive, if applicable (see "Removing a Hard Drive"
on page 47).
NOTE: If a hard-drive bracket is installed inside the hard-drive bay, remove
the bracket before you install the new hard drive.
4
Prepare the new hard drive for installation and check the documentation
for the hard drive to verify that the hard drive is configured for your
computer.
NOTE: If the hard drive you are installing does not have a hard-drive bracket
attached, use your original hard-drive bracket; snap the bracket onto the new
drive.
5
Verify that the hard-drive bay is empty and unobstructed.
6
Slide the hard drive into the hard-drive bay until it clicks securely into
place.
1 hard drive 2 hard-drive bracket
1
2
book.book Page 50 Monday, January 7, 2008 2:53 PM
To Next Page
Loading...
Need help?
General
