Input Source Volume
Quick Select 1
DVD
-40
dB
Quick Select 2 TV/CBl
-40
dB
Quick Select 3
VCR
-40
dB
Quick Select Function
With this function, the currently playing input source, input mode,
surround mode, MultEQ settings and volume
can
be stored in the
memory.
1
Set the input source, surround mode, MuItEQ,
Dynamic EQ, Dynamic Volume, Front Speaker
settings and volume to the conditions you want to
store.
2
Press and hold the desired
QUICK
SELECT
"Memory" appears
on
the display.
The current settings will
be
memorized.
[Quick Select Defaults]
until
Last Function
Memory
This stores the settings
as
they were directly before the standby
mode was set.
When the power is turned back
on,
the settings
are
restored to
as
they were directly before the standby mode was set.
Backup
Memory
The various settings
are
backed
up
for about 1 week, even if the
power
is
turned off or the power cord
is
disconnected.
Resetting
the
Microprocessor
Perform this procedure if the display
is
abnormal or if operations
cannot
be
performed.
When the microprocessor
is
reset,
all
the settings
are
reset to
their default values.
1Turn
ofT
the power using
<POWER>.
ENGLISH
L'
,
I
•
To
call
out the settings, press
aUiCK
SELECT
at which the desired
settings were stored.
• The Quick Select name
can
be
changed (iGf'page
36).
.N.h.
Input sources stored
with
the quick select function cannot
be
selected
if they have been deleted
at
menu"
Manual Setup" - "Option Setup" -
"Source Delete" (iGf'page
36).
In
this
case,
store them again.
Personal
Memory
Plus Function
This function sets the settings (input mode, surround mode, H
OM
I
output mode, MultEQ, Dynamic
EQ,
DynamicVolume, audio delay
etc.) last selected for the individual input sources.
When you switch to
an
input source, the settings
are
automatically
set to the ones that were set the last time that input source was
used.
The
surround parameters, tone settings
and
the volumes of the
different speakers are stored for the individual surround modes.
2
Press
<POWER>
while simultaneously pressing
<INPUT
MODE>
and
<SPEAKERS>.
3
Once the display starts flashing at intervals
of
about 1
second, release the two buttons.
If
in
step 3 the display does not flash at intervals of about 1 second,
start over from step
1.
.,
:.
64
To Next Page
Loading...
Need help?
General
