ENGLISH
_.
1
Remote
Control
Unit
Operations
I
'.
;;
Main Remote Control Unit
(RC-1099)
[Front]
[SOURCE
_--=~H'~'
[SOURCE
CONTROL
1]
~
CONTROL
2]
[Rear]
[ZONE2
OFF]
,
r
9
~1
[MAIN ONI
:888:
[NUMBER]
----188
0!
!_Q,0.-~)
:
..
Q))
.
~
Depending
on
the model
and
year of manufacture of your equipment,
some buttons may not operate.
65
IOperating DENON Audio Components
1Set
[SOURCE
CONTROL
1]
to "AUDIO".
2
Set
[SOURCE
CONTROL
2]
to the position for the
component to be operated (CD, iPodINETWORK or
TUNER).
3Operate the audio component.
*
For
details. refer to the component's operating instructions.
*While this remote control
is
compatible with a wide range of
infrared controlled components, it may
be
the case that some
component models cannot
be
operated with this remote control.
Presetting
• DENON
and
other makes of components
can
be operated by
setting the preset memory.
• Operation is not possible for some models.
1Set
[SOURCE
CONTROL
1]
to "AUDIO" or ''VIDEO''.
*Set to the AUDIO side for the
CD
position,
and
to the VIDEO side
for the DVD/HDP,
VCR,
SAT/CABLE or
TV
position.
2
Set
[SOURCE
CONTROL
2]
to the component to be
registered. .
3
Press
[ZONE2
OFF]
and
[MAIN
ON]
at the same time.
The
indicator starts flashing.
4
Press
[NUMBER]
and input the 3-digit number
of
the
brand
of
the component
to
be preset. The numbers
are shown in the Preset Code Table (IGf'End
of
this
manual).
5
To store the codes
of
another component in the
memory, repeat steps 1 to 4.
•
The
signals for the pressed buttons
are
emitted while setting the
preset memory.
To
avoid accidental operation, cover the remote
control unit's transmitting window while setting the preset
memory.
• Depending
on
the model and year of manufacture, this function
cannot
be
used for some models, even if they
are
of makes listed
in
the list of preset codes.
• Some manufacturers use more than one type of remote control code.
Refer to the included list of preset codes to change the number
and
verify correct operation,
•
The
preset memory
can
be
set for one component only among the
following DVD/HDP
and
SAT/CABLE.
•
VDP
(Video
Disc
Player)
can
be
preset when
[SOURCE
CONTROL
2]
is
set to "DVD/HDP".
IOperating Preset Components I
1Set
[SOURCE
CONTROL
1]
to
"AUDIO" or ''VIDEO''.
*Set to the AUDIO side for the
CD
position,
and
to the VIDEO side
for the DVD/HDP,
VCR,
SAT/CABLE or
TV
position.
2
Set
[SOURCE
CONTROL
2]
to the component you want
to operate.
3Operate the component.
*
For
details, refer to the component's operating instructions.
*Some models cannot be operated with this remote control unit.
To Next Page
Loading...
Need help?
General
