2. Updating via DPMS
Download the latest rmware from our website and update the rmware.
2.1. Network Connection
(1) System Requirements
• Internet Connection by Broadband Circuit
• Modem
• Router
• Ethernet cable (CAT-5 or greater is recommended)
(2) Setting
2.2. Check and update the rmware
Check if there is a rmware update available. It is also possible to check approximately how long the update will take.
(1) Press the "
X
" button to turn on the power button.
(2) "Press "
INPUT
" and "
Cursor
0
/
1
" buttons to select "
Setup
". Press "
ENTER
" button.
• Press "
Cursor
d
/
f
" buttons to select "
General
". Press "
ENTER
" button.
• Press "
Cursor
d
/
f
" buttons to select "
Firmware
". Press "
ENTER
" button.
• Press "
Cursor
d
/
f
" buttons to select "
Update
". Press "
ENTER
" button.
• Press "
Cursor
d
/
f
" buttons to select "
Check for Update
".
(3) Press the "
ENTER
" button.
• "
Connecting...
" is displayed and the unit connects to a DPMS server.
• "
New rmware is available
" is displayed when there is new rmware that can be updated on the server.
There is no need to update when "
Latest Firmware
" is displayed.
(4) Press the "
ENTER
" button, select "
YES
" and press the "
ENTER
" button again.
(5) The rmware update will be initiated.
---Cautions on Firmware Update---
• For the update procedure, a proper broadband Internet connection environment and settings are required.
• Do not turn off the power until updating is completed.
• It takes around 0.5 hour to complete the update.
Once an update is started, normal operations cannot be performed until it is completed.
Also, setting items may be initialized.
Note down the settings before updating, and set them again after updating.
モデム
イン ター ネ ット
パソコン
LANポート/Ethernet端子
本機のETHERNET端子
ルータ
WAN側へ
LANポートヘ
LANポートヘ
28
To Next Page
Loading...
Need help?
General
Weight and Dimensions
