41
8514-311-001 REV PR
This touch pad switch allows the dryer controller to enter the temporary
programming mode
.
This touch pad switch will stop the dryer during a dry cycle without clearing
the present drying cycle if pressed once. If pressed and released twice,
consecutively, the present dry cycle will be cleared
.
This touch pad switch will start the operation of a dry cycle if pressed and
released once. Pressing and holding this touch pad switch will display the
current temperature of the dryer heat sensor as long as it is held in the
depressed position
.
7.2.2.3 4-DIGIT NUMERICAL DISPLAY MESSAGES
Description
LOAd This message is displayed after a dry cycle is complete and the
dryer loading door has been opened or the STOP touch pad switch
on the dryer controller has been pressed and released twice.
donE This message blinks immediately after completion of the dry cycle
and continues to blink until the STOP touch pad switch on the dryer
controller is pressed or the dryer loading door is opened.
Prog This message is displayed when entering the permanent
programming mode.
.15 This message appears while the dryer is in the heating time of a dry
cycle. The decimal point will blink if the output for the gas valve is
on or remain on constantly if the output for the gas valve is not on.
The number represents the total time left in the dry cycle (includes
cool down time).
C02 This message appears when the cool down time of the dry cycle is
reached. The letter “C” represents the cool down (non-heating) part
of the dry cycle. The number(s) after the letter “C” represent(s) the
total time remaining in the dry cycle.
F5 This message appears if there is a dryer fault. The letter “F”
indicates a fault and the number after the “F” represents the specific
fault that has occurred. There are five different faults that can
appear (F1 through F5).
Figure 7-11 Cycle
Figure 7-12 Stop
Figure 7-13 Start
To Next Page
Loading...
Need help?
General
