To Next Page

To Previous Page

8514-311-001 REV PR

8. Press and release either the UP or DOWN touch pad switch on the dryer controller to

change the cool down time. Once either the UP or DOWN touch pad switch is pressed,

the temperature L.E.D. and the cool down time on the 4-digit numeric display will flash. If

you press and hold down either the UP or DOWN touch pad switch, you will increment

(UP arrow) or decrement (DOWN arrow) through the cool down times available (2

through 60 minutes if the controller has a red dot sticker or 2 through 15 minutes if the

controller has no red dot sticker, If 170 degrees or higher 4 minute minimum). To not

change the cool down time, do not press either the UP or DOWN touch pad switch. Go

to the next step.

9. Press and release the SELECT/ENTER touch pad switch on the dryer controller. Once the

SELECT/ENTER touch pad switch is pressed and released, the cool down L.E.D. and the

programming L.E.D. will switch off, the dry cycle L.E.D. will remain on, and the flashing

cool down time on the 4-digit display will stop flashing and remain.

10. At this point, you have two choices:

a. You can perform the modified dry cycle by pressing and releasing the START

touch pad switch on the dryer controller touch pad. If you start the modified

cycle, the total dry time will appear on the 4-digit numeric display and it will

count down to 0 as the dry cycle progresses.

b. You can clear the modified dry cycle program by pressing and releasing the STOP

touch pad switch. If you choose to clear the modified dry cycle, the 4-digit

numeric display will change to “LOAd”.

7.4.3.1 Temporary Dryer Controller Programming Procedure Example

REQUIREMENTS: Dry a load with 40 minutes of actual heat at 185°F and five minutes of cool

down.

The following procedure will show you how to temporarily modify the existing dry cycle 1

program for one cycle of drying. It is based on the assumption that the factory defaults have not

been permanently changed. If they have been changed, the steps of this procedure will be the

same, but the values that are displayed will be different. The amount of times that the UP or

DOWN touch pad switches of the dryer controller must be pressed and released may also be

different.

If you want the change to be permanent, go to section 7.4.4 Permanent Dryer Controller

Programming.

Procedure:

1. After the load has been placed in the dryer, press and release the UP or DOWN touch

pad switch on the dryer controller until the L.E.D. for dry cycle 1 is illuminated.

2. Press and release the CYCLE touch pad switch on the dryer controller. You will see the

number “35” on the dryer controller display. The programming L.E.D. and dry time L.E.D.

will be illuminated.

Dexter Laundry B Series User Manual

Other manuals for Dexter Laundry B Series