Dexter Laundry B Series User Manual

52
8514-311-001 REV PR
3. Press and release the UP touch pad switch on the dryer controller 10 times so that the
display will show a flashing “45”. When the UP touch pad switch is pressed the first time,
the number “36” will be flashing on the dryer controller display. Each number after that
will also flash.
4. Now, press and release the SELECT/ENTER touch pad switch on the dryer controller.
The number “45” will stop flashing, the dry time L.E.D. will switch off, the dryer controller
display will now show “180”, the temperature L.E.D. will illuminate, and the programming
L.E.D. and dry cycle 1 L.E.D. will remain on.
5. Press and release the UP touch pad switch on the dryer controller one time so the
controller display will show a flashing “185”. Each press of the UP touch pad switch will
increment the temperature by five degrees.
6. Now, press and release the SELECT/ENTER touch pad switch on the dryer controller.
The number “185” will stop flashing, the temperature L.E.D. will switch off, the dryer
control display will now show a number “5”, the cool down L.E.D. will illuminate, and the
programming L.E.D. and dry cycle 1 L.E.D. will remain on.
7. Press and release the SELECT/ENTER touch pad switch on the dryer controller, since the
desired cool down time is five minutes. After you press the SELECT/ENTER touch pad
switch, the cool down L.E.D. and programming L.E.D. will switch off, the controller display
will remain at “5”, and the cycle 1 L.E.D. will remain on.
You are now ready to start the new dry cycle. The new dry cycle will be in effect for one
dry cycle only. After the dry cycle is done, or if the STOP touch pad switch on the dryer
controller is pressed and released twice, consecutively, the cycle 1 program will revert to
the factory default settings.
If you press the START touch pad switch on the dryer controller, the controller display will
change from the number “5” to the number “45” and dry cycle 1 will begin.
7.4.4 Permanent Dryer Controller Programming
The permanent programming mode will allow the change of the stored dry cycle settings in
the dryer controller until the operator physically changes them again. The factory default settings
can be restored in the dryer controller by pressing the default settings push-button on the back
(component) side of the dryer controller circuit board. It is labeled and located at the lower
middle side of the printed circuit board, as you face the component side of the board. It must be
pressed and held down for at least three seconds.
To permanently change a dryer controller cycle, follow the procedure below. Things that are
displayed on the 4-digit numeric display will be in “quotation marks”. Touch pad switches on the
dryer controller that physically need to be pressed will be in CAPITAL AND BOLD LETTERS.
If, at any time, you want to escape the permanent programming mode while changing the
settings, you can press the STOP touch pad switch on the dryer controller if the 4-digit numeric
display is not flashing. The SELECT/ENTER touch pad switch on the dryer controller can be
pressed and released to enter the flashing value shown on the 4-digit numeric display and allow
you to escape.

Dexter Laundry B Series Specifications

General

Brand	Dexter Laundry
Model	B Series
Category	Dryer
Language	English