Digi PortServer II User Manual

90030500B Configuring Modem Connections Page 131
State parameters
You can use any of the following state parameters in place of
s
in the commands listed
above.
PortServer II take action(s) if any of these exit commands are issued. For example, a
retry timer is provided for both remote system busy and remote system down exit
conditions. Remote system busy causes PortServer II to try the next number in the
dialer script.
Un
Immediately executes (uses) the text of state definition
n
as if it were
inserted to replace this command. You can nest this command, up to a
maximum of 10.
W+m
Waits for a modem signal to become high. If
m
is
1
, waits for DCD
high. If
m
is
2
, waits for CTS high.
W-m
Waits for a modem signal to become low. If
m
is 1
,
waits for DCD
low. If
m
is
2
waits for CTS low.
[
string
]
s
Declares that a transfer to state
s
should be performed when
string
is
received on the communication line.
n
Transfer to state
n
, where n is a decimal number in the range 1 to 24.
+
Exit, indicating success.
-
Exit, indicating general failure.
*
Exit, indicating remote system is busy.
=
Exit, indicating remote system is down.

Digi PortServer II Specifications

General

Brand	Digi
Model	PortServer II
Category	Server
Language	English