Page 60 Basic Configuration 90030500B
On-Line Help
On-line help screens are available for the PortServer II's commands. Help is displayed
if you enter a “
?
” by itself or after part of a command line. The help screen will tell
you which parameters are available to complete the command line.
Help menu
Enter a “
?
” after the PortServer II prompt with no other parameters to get the top level
help screen, as shown below:
login: root
passwd:
#> ?
admin boot close cpconf
exit info kill mode
newpass ping quit rlogin
send set snmp status
telnet traceroute wan who
?
#>
Command-specific help
For help on a specific command, type the command name followed by a question
mark. The example below asks for help for the command
info
:
#> info ?
Displays or clears statistics tables.
syntax: info (table_name)|(table_cmd)
tables:
frame ip icmp tcp
udp clear
#> info
Note:
After you enter a request for help, PortServer II prints the command before
the “
?
” for you on the next command line, anticipating that you will enter the
command next. For example, after the request for help with
info?
above,
notice how the next command prompt is followed by the word
info
.
To Next Page
Loading...
Need help?
General