Page 174 Configuring Frame Relay 90030500B
4. Configure a user for each WAN connection, using the
set user
command. See
Chapter 4, Basic Configuration
and
Chapter 8, Configuring WAN Connections
for more information. Ensure that you set the user’s protocol to
FrRelay
. The
user must also be configured to use IP addresses, by setting
IPAddr
to the
remote IP address of the Frame Relay service. The local IP address should be set
to 0, allowing the PortServer II’s Ethernet address to be used.
5. When configuration is complete, start the Frame Relay link by entering:
set user <name> dialout=on
To Next Page
Loading...
Need help?
General