Digi PortServer II User Manual

90030500B Troubleshooting Page 229
5) <name>: Menu access enabled with no menu selected.
The user was configured for access via a menu but no menu is defined.
6) <name>: Menu number references undefined menu
The user is configured to use a menu that is not defined.
7) <name>: Syntax error in AccessTime string.
The user is configured for access only at certain times or on certain days, and there is
a syntax error in the configuration.
8) <name>: Invalid subnet mask for dynamic/negotiated IP address.
For negotiated or dynamic IP addresses, WAN users must have an IP mask of
255.255.255.255.
9) <name>: Negotiated IP address can only be used with PPP.
It is not possible to used address negotiation with the currently configured protocol.
Only the PPP protocol supports address negotiation.
10) <name>: Keepup filter ineffective with no idle timeout.
If you do not configure an idle timeout, there is no requirement for a keepup filter (the
keepup filter resets the idle timer).
11) <name>: Bringup/Keepup/Passpacket/Logpacket filter not found.
One of the filters configured in the user's profile was not defined by
set filter
.
12) <name>: Must specify a device for outgoing connections
You cannot enable dial out without first defining a device to dial out on.
13) <name>: Device name not found in device table
The user's profile is configured to use a device that is not listed in the Device Table.
14) <name>: No frdlci information for port <port> dlci <dlci>
You must define an entry in the frdlci table to correspond with the port/dlci pair for
this user.
15) <name>: Port <port> not configured for frame relay.
Use the
set frame
command to enable Frame Relay for this port.

Digi PortServer II Specifications

General

Brand	Digi
Model	PortServer II
Category	Server
Language	English