© 2014 Digi International Inc. 56
XBee/XBee-PRO
®
DigiMesh 2.4 User Manual
Query Sleep Cycle
The OS and OW command can be used to query the current operational sleep and wake times a
module is currently using.
Sleep Status
The SS command can be used to query useful information regarding the sleep status of the
module. This command can be used to query if the node is currently acting as a network sleep
coordinator, as well as other useful diagnostics.
Missed Sync Messages Command
The MS command can be used to query the number of cycles that have elapsed since the module
last received a sync message.
Sleep Status API Messages
When enabled with the SO command, a module configured in API mode will output modem
status frames immediately after a module wakes up and just prior to a module going to sleep.
To Next Page
Loading...
Need help?
General
