68
Pairing Your Remote Control
PAIRING YOUR REMOTE CONTROL
These instructions help you pair your remote control to your Hopper or Joey receiver. Your
Hopper adn Joey come with a Universal UHF/IR remote control that uses proprietary
ZigBee® RF4CE technology. It includes two-way learning functionality and the ability to
control up to three additional devices such as TVs and DVD players via IR commands.
You will not be able to pair a remote that is already paired to a Hopper or Joey receiver in
your home. To identify which Hopper or Joey a remote is paired with, you can use the
Locate Remote feature (press the LOCATE REMOTE button on your receiver front panel)
to have the remote paired with the receiver emit a series of beep tones to identify it.
To pair your remote control
1 Make sure the remote control has fresh batteries installed and is in SAT mode.
2 Press the SYSTEM INFO button on the receiver front panel to display the System
Information screen on the nearby TV.
3 Press and release the SAT button on the remote control:
• Remote 1—Press SYS INFO on the receiver front panel. The System Information
screen lists your remote control. Typically, the remote control for the nearby TV is
shown on the Hopper’s screen and the remote control for a remote TV on the Joey’s.
• Remote 2, 3, ..., 8—As many as eight remote controls can be paired to a receiver and
listed in the System Information screen. If you have more than two DISH remote
controls, then consult the SYSTEM INFO screen on each of the receivers to ensure
that all the remote controls are paired with the correct receivers.
4 Select Close to close the System Information screen.
Press SAT
Close
Press Close
If no operation,
press SYSTEM INFO
on the receiver
(image may vary)
To Next Page
Loading...
Need help?
General
