79
The Locate Remote feature
To set the remote control back to adjusting the TV’s device volume by default (steps 1-5
set up the remote control and steps 6-7 verify that the remote has been set up correctly):
Programming to Control a Second Satellite Receiver
If you have another DISH satellite receiver installed in your home, you can use this new
remote in AUX mode to control it along with your new receiver. When you program the
remote to control another receiver, the remote will send out IR signals to the receiver. You
can program the remote to control certain other DISH satellite TV receivers, such as the
ViP® 922 SlingLoaded® DVR.
THE LOCATE REMOTE FEATURE
Ever misplace your remote control somewhere in your home and wonder where it is?
Press the LOCATE REMOTE button on the front panel of your Hopper HD DVR (behind
the left panel door) or Joey Receiver if you cannot find your remote.
Within a few seconds you should hear your remote control emitting a series of beep tones
to help you locate it. (If the remote control is out of range of the DISH receiver or its
batteries are dead, you will not hear these tones.)
When you find your remote control, press and hold the SELECT button on it and the
beeping will stop. Then you can use the remote control normally.
To Next Page
Loading...
Need help?
General
